スポンサーリンク Sponsored Links
preference新着記事

How to wrap bar tape on a road bike for beginners [Blog58]

preference
記事内に広告が含まれています The article contains advertisements

This time, we would like to talk about the site administrator’s hobby, road biking (bicycles).

We will talk about how to change bar tape in an easy-to-understand way for beginners.

What to prepare

  • Vinyl tape
  • Scissors
  • New bar tape for replacement

The bar tape to be used is from the manufacturer “Dizna”.

[Image: Tap to enlarge]

1 Bar tape

2 Decorative tape

3 Endcap

4 Bar tape for eye strainer (not used this time)

5 Tape for bar tape fastening

Used bar tape

[Image: Tap to enlarge]

Look at this! This used bar tape! It is white, frayed and deteriorated!

They say you can see the rider’s ability when you look at the deterioration that has occurred with use, but what do you see?

Tap the image to enlarge it!

Bracket Cover & End Cap

[Image: Tap to enlarge]

First, flip up the bracket cover.

It is stiff, but can be turned by hand.

[Image: Tap to enlarge]

Then remove the end caps.

Remove a little at a time with a flat-blade screwdriver, etc.

Start winding from the lower handle.

[Image: Tap to enlarge]

(1) Start wrapping the bar tape by extending it 1 cm beyond the tip of the lower handle.

(To fold the bar tape stretched 1cm into the hole of the drop handle and fasten it with the end caps)

(2) Wrap the bar tape from the lower handle in the direction of the red arrow

Inner roll? or outer? Either one is fine.

It is better to focus on the fit when you hold the handlebars to see if it is right for you!

Wrap around the base of the dual controller lever, a difficult area.

This time, I’m going to wear it across my body.

[Image: Tap to enlarge]

(1) Wind upward in the direction of the red arrow.

[Image: Tap to enlarge]

(2) Then wind horizontally in the direction of the red arrow.

(3) Wind upward in the direction of the green arrow.

[Image: Tap to enlarge]

Finish winding up to the top of the drop handle

Check if the bracket rubber hides the dual controller levers (red circle)

If you think you’ve failed here, don’t give up!

If you peel it off calmly and cleanly, you can redo it (the site administrator tried three times).

Decorative Tape & End Caps

[Image: Tap to enlarge]

(1) Apply tape for bar tape fastening.

(2) Apply decorative tape

[Image: Tap to enlarge]

(3) Fold over the excess bar tape and tighten it with the end caps.

Some people do not stop the end caps to save weight, but there have been actual cases of drop handlebars sticking into the human body when falling from a bike.

It hurts when it stings.

Be sure to tighten the end caps!

When finished, it looks like this

[Image: Tap to enlarge]

Bar tape that has run with time since 2019

[Image: Tap to enlarge]

Red bar tape given by Red Comet

At the end

I’m hoping to post a road bike (bicycle) blog as well, although I’m not sure when the next one will be!

This is my 10th year of road biking, and I’d like to take this as a reminder.

Lousy!

[Sponsor Links]

Dixna ディズナ スクラッチ バーテープ ロードバイク 自転車

価格:1,894円
(2022/12/25 13:46時点)
感想(0件)

コメント Comment

TRANSLATE »
タイトルとURLをコピーしました